Owner`s manual

26
ADAT
– The Alesis ADAT optical interface can send and receive up to 8
simultaneous channels of digital audio data over fiber optic cables. Unlike
wire cables, fiber optic cables do not add noise or interference. Mona can
send out (or “master”) ADAT clock as well as slave to it. If you want Mona
to slave to an ADAT clock, just set Mona’s input clock to the
ADAT
setting. Mona can only sync to ADAT clock if the master device is set to a
sample rate between 40kHz and 50kHz. Otherwise you will get noise
and/or loss of sync.
Note:
To preserve the high audio quality of Mona’s converters it is best to
use Mona’s
Internal
input clock setting instead of synchronizing to an
external ADAT clock, which may add unwanted jitter to the signal.
Esync
– Esync is a proprietary form of super clock that is used to
synchronize two or more Echo 24-bit products like Mona, Layla24, Gina24,
and Darla24. While Gina24 and Darla24 have both input and output
connectors on their PCI cards, Mona and Layla24 only have the Esync
output connectors. Mona is always outputting Esync clock. For more
information please read step 6 in the section entitled “
Installing the Mona
Hardware
” in this manual.
Now let’s take a look at some possible configurations and how you might
set them up from a synchronization standpoint.
Let’s start simple. Suppose that Mona is the only audio device used in your
system. Since you have no other devices to synchronize with, simply select
Internal
for Mona’s input clock. Mona will then use its own clock to
control its operation.
Now a little more complicated set-up: You have two Monas connected.
Simply set Mona #1 to
Internal
for its input clock. Now connect the first
Mona to the second one via a BNC cable running from Word Clock Out on
Mona #1 to Word Clock In on Mona #2. Now select
Word
for Mona #2’s
input sync. The second Mona will slave to the first one and your Monas will
now operate in unison.
No matter how many devices you are synchronizing, the concept is
essentially the same. You are merely “daisy-chaining” devices together