Owner`s manual

Digital Mode Switch

To the right of the Input clocks is a dropdown menu labeled “Digital Mode

Switch.” This menu allows you to select which digital inputs/outputs Mona

will use at any given time. The options are S/PDIF RCA, S/PDIF Optical,

and ADAT. Mona can only use one digital mode at a time. When one of

the two S/PDIF modes is selected, the “View ADAT Ctrls” checkbox will

be greyed out. You can only access the ADAT controls when the ADAT

mode is currently selected.

Note:

Sample rates above 48kHz will not be available while ADAT mode

is selected. This is because ADAT does not support sample rates higher

than 48kHz.

View ADAT Ctrls

While you are in the ADAT digital mode, you can view the Console ADAT

controls at any time by checking the “View ADAT Ctrls” checkbox. As

seen below, these controls are the same as the analog input, monitoring, and

output controls. The only exception is the lack of controls for the ADAT

outputs. If you want to go back to the analog controls, just uncheck the

“View ADAT Ctrls” checkbox. You cannot monitor the ADAT inputs

through the S/PDIF outputs.

Note:

If at any time you switch the digital mode to one of the S/PDIF

options, the ADAT controls will become unavailable and the Console will

return to displaying the analog and S/PDIF controls.