Owner`s manual

Look at the list of MME outputs. Disable each entry that does not represent

an actual piece of hardware. Specifically, if you see Retro AS/1, Reality, or

Gigasampler listed, disable them (select the entry with the mouse, and then

click the “Set inactive” button).

Go ahead and run Cubase. Make sure you can select our ASIO driver and

that it works. So far so good, now exit Cubase.

The next step depends on what other software you have installed:

Reality and Cubase VST

If you want to use Reality with Cubase VST and our hardware, run the

“Setup MME” program again. Set Reality as an active output.

Now, before you run Cubase VST, make sure you run Reality first. Then,

make sure that Reality is not using outputs 1 and 2 of your card. Cubase

will always try to use outputs 1 and 2. If some other program is using these

two outputs already, Cubase will not be able to start the ASIO driver and

you will get many error messages.

Once you've got Reality running and set up properly, go ahead and run VST.

Gigasampler and Cubase VST

NOTE:

You must have “GSIF enabled” selected in the Mia properties

page in order to use Gigasampler with Mia.

This is very similar to the directions for using Reality. Run the “Setup

MME” program again. Set Gigasampler as an active output.

Now, before you run Cubase VST, make sure you run Gigasampler first.

Then, make sure that Gigasampler is not using outputs 1 and 2 of your card.

Cubase will always try to use outputs 1 and 2. If some other program is

using these two outputs already, Cubase will not be able to start the ASIO

driver and you will get many error messages.

Once you've got Gigasampler running and set up properly, go ahead and run

VST.