Owner`s manual

Problem: Recordings made using the S/PDIF port contain occasional pops
or skips.
Solution: When recording with the S/PDIF port, you must manually select
the S/PDIF clock as the input clock. This can be done using the Console.
Problem: (Layla24 and Gina24) You keep hearing a high-pitched squealing
sound or your S/PDIF or ADAT signal has gone crazy.
Solution: Reset the sample rate of your Echo card. You may have set the
sample rate to 11kHz or 22kHz. Because neither S/PDIF nor ADAT support
these rates, you will have problems syncing until you reset the sample rate to
one within spec (like 44.1 or 48kHz). You can do this through your ASIO
program’s controls or by playing an audio file of the appropriate sample rate
through your Echo hardware’s outputs. Then you will be able to sync
properly.
Problem: The sound cuts in and out, or the left or right channel doesn’t
work.
Solution: You may have a bad audio cable. Try using a different cable in
the problem channel.
Problem: There is no sound unless I pull the audio plug out a little.
Solution: Not all ¼” plugs are made to the exact same dimensions. Try a
plug/cable from a different manufacturer.
62