Owner`s manual

Console – Mac OS 8/9, Layla24 and Gina24

position. Note that this does not affect your recording. Below the pan slider

is the monitor mute. This controls whether or not you want this input

channel to be mixed directly out to the currently selected output bus. Again,

this does not affect recording. This is followed by the monitor fader, and it

controls the input monitor level. Like the pan and mute controls, this does

not affect your record level. Also, clicking on the readout below the fader

will allow you to numerically enter a fader setting.

The analog inputs also have gang buttons, and their operation is the same as

the gang button for the master outputs.

Digital inputs: The controls for the digital inputs are outlined in light blue

and have the label “digital in” at the bottom. Their operation is identical to

the analog input controls except the digital input controls don’t include a

nominal level button.

For Layla24 and Gina24, whether you are monitoring the S/PDIF or the

ADAT inputs depends upon the digital mode you have selected. If you are

in either S/PDIF mode, the S/PDIF inputs will come in digital inputs 1 and

2. If you are in ADAT mode, the ADAT signal will come in on all eight

digital inputs.

Playback strips: The controls for the level of audio being played by an

application are outlined in orange and have the label “playback” at the

bottom. Notice you cannot pan or otherwise redirect here; if you are playing

out of analog 1 and 2 from your application, it will only be sent to that same

bus.

Clock and digital mode settings: The area within the yellow outline on the

upper right lets you select your sync source and digital mode. If a given

clock is detected, the green indicator next to the clock button will light up.

You will only be allowed to select clocks that have been detected. Also, you

may only select the digital mode if the there aren’t any applications actively

playing or recording.

Note: Sample rates above 48kHz will not be available while ADAT mode is

selected. This is because ADAT does not support sample rates higher than

48kHz.

Console – Mac OS 8/9, Layla24 and Gina24