Owner`s manual

VxD console- Mia

VxD console – Mia

monitoring through the digital outputs that are hidden from view. Clicking on the

large “Output Controls” button labeled “Digital” at the bottom of the console will

display the monitor controls for monitoring through the digital outputs. These

controls are labeled “

Analog => Digital” and “Digital => Digital”.

The monitors are one of the most powerful functions of the console. When you are

recording, these controls allow you to set the level at which each input signal will

be monitored at each of the outputs, independent of the main output level control.

When setting a monitor level, you must first select whether you are adjusting the

monitors for the analog or digital outputs by clicking on the appropriate “Output

Controls” button on the bottom of the console. Then adjust the input that will be

monitored. Selection of the input is really just a matter of using the correct

monitor control box. A monitor setting will always affect the input pair that is

directly above it. To set the monitor for the analog inputs, for example, simply go

to the monitor control directly below the analog inputs and click on one of the

buttons found in the center of the control.

Let’s say you want to set the level at which the analog inputs are monitored

through the S/PDIF outputs on Mia. You would first click on the “Digital” output

control button at the bottom of the console to select the digital controls. Then you

would adjust the monitoring levels by using the sliders and buttons within the

monitor control labeled “Analog => Digital). The console program remembers

any settings that you make, and all settings for all outputs are maintained

independently.

Remember that all of the monitor controls remain in effect even when they’re not

displayed. The degree of attenuation (or muting) of each level is set by the

monitor controls. The console program constantly maintains a level setting for

each of the monitor paths it controls. Clicking on either the “Analog” or “Digital”

output control button simply selects the settings that are displayed.