Owner`s manual

VxD console- Mia
52
VxD console – Mia
into a box that contains selection buttons, faders, and other controls and displays
as determined by the function.
Input Controls
Let’s take a look at the control surface. The input
control area is located in the upper left portion of
the console surface. For each input device pair you
will find a pair of input meters. In addition, the
analog inputs have controls that allow you to select
between +4 dBu (professional) input levels or –10
dBV (consumer) input levels. Clicking on the
button will toggle back and forth between the two
levels.
Monitor Controls
Below the input channels are the input monitor
controls. These allow you to monitor the input
signal via any of the outputs on your Mia. Each
input channel pair has a corresponding monitor
control pair directly below it on the console. At the
top of each monitor pair are radio buttons that
allow you to selectively mute (M) or solo (S) each
channel. In the middle you will find a pair of faders
that will allow you to set the levels of the monitor
signals. At the bottom of the control area there is a
radio button that allows you to “gang” (G) the
faders. Ganging the faders ties them together so that they will maintain their
relative placement with regard to each other. Below each fader is its corresponding
pan control. In the default pan positions (see example below) the signal from input
1(left) will be monitored by output 1(left), and the signal from input 2(right) will
be monitored by output 2(right). Moving a pan control will determine how much
of the input signal is sent to each output channel in the selected output pair. Both
pan controls and faders can be reset to default by pressing the Ctrl button and left
clicking on the control.
Notice that the monitor controls are labeled at bottom indicating which input is
being monitored and which output they are going to. In the pictures above,
controls for the analog outputs are shown. There is a duplicate set of controls for