Owner`s manual

Audio connections – Gina24

Connecting to Gina24’s Audio Interface

The back panel of Gina24’s audio interface contains a wide variety of connections

that allow great flexibility in the operation of Gina24. To achieve the optimal

performance with Gina24, it is critical that the appropriate cabling and connectors

are used.

Analog Inputs and Outputs

Gina24 has two analog inputs and eight analog outputs on the front panel. The

input and output connections can accept balanced or unbalanced jacks via ¼”

connectors. Both the inputs and outputs are set to receive or send a +4 dBu

(balanced) signal.

Gina24’s front panel also has a ¼” headphone output jack with a corresponding

volume knob which monitors analog outputs 1 and 2.

The Computer Connector

On the back panel of the Gina24 audio interface box is a connector labeled

COMPUTER. It is the point at which the audio interface connects to the Gina24

PCI card inside your computer.

A cable was supplied with your Gina24 for this purpose. This custom made cable

is manufactured to certain specifications; if you need to replace it, you should only

use a replacement cable from Echo.

Please Note: The Gina24 cable is NOT interchangeable with Darla24 or

Gina (20-bit) cables.