Owner`s manual

12
Output Bus select (Indigo dj only)
The Output Bus select panel is the area in the middle right of the Console.
Each bus has its own button marked with an A (for analog) and a channel
number pair. The button that is green is the currently active bus. Clicking
on an output bus button simply selects the settings that are displayed. In this
case Analog 1-2 (A1-2) is the active bus. This means all parameters such as
volume, pan, and mute apply to the audio coming out Analog outputs 1 and
2 of Indigo dj. To select an output bus, click on one of the buttons.
Master Output Bus Control
The master bus control is the area on the bottom right of the Console. The
example above shows the Indigo dj Console. At the bottom is the label
“Analog 1-2.” This indicates you are currently controlling everything mixed
to analog outputs 1 and 2. Indigo and Indigo io only have controls for
Analog 1-2.
The mute buttons and faders affect everything being mixed to this bus.
Clicking on the readout below the fader will allow you to enter a numerical
value for the fader setting.
The gang button, marked with a “G,” sets the gang mode. If you are in gang
mode, the mute buttons will work together for the left and right channels; for
example, clicking the mute on one channel activates the mute button on the
other channel. Also, ganging the faders ties them together so they will
maintain their relative placement with regard to each other. Holding down
the Shift key reverses the state of the gang button; that is, if the gang button
is down, holding down shift puts you in non-ganged mode and vice versa.