Owner`s manual

Now, before you run Cubase VST, make sure you run Gigasampler first.

Then, make sure that Gigasampler is not using outputs 1 and 2 of your card.

Cubase will always try to use outputs 1 and 2. If some other program is

using these two outputs already, Cubase will not be able to start the ASIO

driver and you will get many error messages.

Once you've got Gigasampler running and set up properly, go ahead and run

VST.

If you want to use both Gigasampler and Reality, you'd better have a really

good computer. If you do, just make sure you start both of them before

VST.

Retro AS/1 and Cubase VST

Unfortunately, we haven't been able to get Retro AS/1 to work with Cubase

at the same time. This is mainly because we couldn't find a way to tell

Retro AS/1 to use any outputs other than 1 and 2. Even if you start Retro

first, both Retro and Cubase end up fighting over outputs 1 and 2 and

nobody's happy.

We'll keep looking into this. You could easily use them both if you had two

sound cards (either two of our cards or one of our cards & one from

someone else).

Gigasampler

Q: I'm a Gigasampler user. Anything I should know about?

Yes. Unfortunately, Gigasampler does not work with Gina24, Layla24 or

Mona at this time. Nemesys (makers of Gigasampler) will be releasing an

update patch soon that will add support for Gina24, Layla24 and Mona. We

will also be releasing a driver update at that time. Both the Gigasampler

patch and the Echo driver update will be required to use Gigasampler with

our new products.

Q: Once I get the update, is there anything else I should know about?