Owner`s manual

27
Digital Mode Switch
To the right of the Input clocks is a dropdown menu labeled “
Digital Mode
Switch
.” This menu allows you to select which digital inputs/outputs
Gina24 will use at any given time. The options are
S/PDIF RCA
,
S/PDIF
Optical
,
ADAT
, and
S/PDIF CD ROM
. Gina24 can only use one digital
mode at a time. When one of the three S/PDIF modes is selected, the “
View
ADAT Ctrls
” checkbox will be grayed out. You can only access the ADAT
controls when the ADAT mode is currently selected. To use the S/PDIF
CDROM mode you must connect your Gina24 PCI card to a CDROM drive
with a functioning
digital output. Not all CDROM drives do. Check with
your CDROM drive manufacturer if you’re not sure.
Note:
Sample rates above 48kHz will not be available while ADAT mode
is selected. This is because ADAT does not support sample rates higher
than 48kHz.
View ADAT Ctrls
While you are in the
ADAT
digital mode, you can view the Console ADAT
controls at any time by checking the “
View ADAT Ctrls
” checkbox. As
seen below, these controls are the same as the analog input, monitoring, and
output controls. The only exception is the lack of controls for the ADAT
outputs. If you want to go back to the analog controls, just uncheck the
“
View ADAT Ctrls
” checkbox. You cannot monitor the ADAT inputs
through the S/PDIF outputs.
Note:
If at any time you switch the digital mode to one of the S/PDIF
options, the ADAT controls will become unavailable and the Console will
return to displaying the analog and S/PDIF controls.