Owner`s manual

For more information please read step 6 in the section entitled “

Installing

the Gina24 Hardware

” in this manual.

Now let’s take a look at some possible configurations and how you might

set them up from a synchronization standpoint.

Let’s start simple. Suppose that Gina24 is the only audio device used in

your system. Since you have no other devices to synchronize with, simply

select “Internal” for Gina24’s input clock. Gina24 will then use its own

clock to control its operation.

Now a little more complicated set-up: You have two Gina24s connected.

Simply set Gina24 #1 to “Internal” for its input clock. Now connect the first

Gina24 to the second one via an Esync cable running from Esync Out on

Gina24 #1 to Esync In on Gina24 #2. Now select Esync (or Esync 96 kHz)

for Gina24 #2’s input synch. Your Gina24s will now operate in unison.

No matter how many devices you are synchronizing, the concept is

essentially the same. You are merely “daisy-chaining” devices together

using compatible clocks. One device will operate as the source of the master

clock, with each successive device using that clock to sync.