Owner`s manual

Console - Mia

At the top of this area you will see the label “Analog out 1-2”. This

indicates that you are currently controlling everything that will be mixed out

to analog outputs 1 and 2, which corresponds to the green “A 1-2” on the

bus select panel.

The two buttons labeled “+4” are the nominal level select buttons. Since

they both read “+4”, this indicates that these outputs are sending a +4

signal. To send a –10 signal, click the button.

The mute buttons and faders affect everything being mixed to this bus; that

is, pulling the fader down will make both the input monitors and playback

quieter.

Below each fader is a readout displaying the current fader setting. You may

click on the readout and enter a gain value directly.

Analog inputs: Next up is the area all the way to the left within the red

outline. This area is divided up into two vertical strips. These are the

controls for the analog inputs. Since Mia only has two analog inputs, only

two strips are shown. The controls on these strips have to do both with

what you record and what you are listening too right now (i.e. the input

monitor).

The topmost control is a button labeled “+4”; this button will allow you to

select the nominal level for this analog input. Since the button currently

reads “+4”, it is ready to accept a +4 signal. Click the button to change this

input to –10 mode. This button will affect the level of what you record as

well as the monitor level.

Below that is the peak meter for this channel. The red segment of the peak

meter starts at –3 dB and the yellow starts at –12 dB.

Next is the monitor pan knob; this pans the input channel between the two

channels of the output bus. Note that this does not affect what you record.