Owner`s manual

20
buttons on the bottom left. These buttons allow you to select an output
channel.
When button 1 is selected, all of the monitor controls affect what goes to
output 1. Note that it says
Out 1
at the bottom of every channel. This will
change according to whatever button is selected. The console will
remember the changes you have made to each output even though you can
only see one at a time. Take note that these controls are for the routing of
audio signals from the Darla inputs to the Darla outputs only. The console
does not control output that is generated by your computer (such as aiff
files). That is controlled by whatever audio program(s) you may have.
Remember that all of the inputs are continuously monitored by all of the
outputs at some level. The degree of attenuation (or muting) of that level is
set by the monitor controls. The console program constantly maintains a
level setting for each of the 16 monitor paths it controls. Clicking on an
output selection button simply selects the settings that are displayed.