Instruction Manual

Step 1. Gently press the two pins for the stock and one pin for the hand
guard out and away from the body of the gun. You will have to remove the
stock and hand guard for battery install.
Step 2. To insert the 9.6v stick battery first straighten the wires if needed.
Notice the wire along side the row of battery cells. Keep the wire or spine to
the bottom left or right as you slide the battery into the gun.
Step 3. Slide the stick battery all the way into the gun. Make sure the wire
spine is on either side on bottom side for correct install. You might have to
use a tool to pull the plug out the other end.
Step 4. Gently pull the plug out and connect the plugs. Once the battery is
installed you can leave in the gun for recharge if desired. Reverse the steps
to install the stock and hand guard.
FUSE Holder
Battery Charging
Battery Installation
Charge the battery for 3 hours for the first time. When charging have the
battery away from ALL COMBUSTIBLE MATERIALS and on a cool hard
surface. If battery becomes HOT remove and charger and let it COOL before
use. When cycle rate becomes slow, STOP shooting and remove the maga-
zine. Shoot 2 times in SEMI to clear the gun, remove the battery and recharge.
Basic Charge Time:
Battery: 1500 mAh / Charger: 300mAh = Estimated Charge Time: 5 Hours