Instruction Manual

Hop Up Unit Adjustment Hop Up Unit Cleaning / Unjam Gun

To unjam the gun,

Turn Hop Up Unit OFF - Disconnect Battery - Remove Magazine

Step 1. Use the Angled end of the cleaning rod to push the BB backwards

and out through the Hop Up Unit.

Step 2. Make sure to have the angled end facing down and silicone oil will

help loosen the BB.

NOTE: If you continue to fire the gun with a jam you will cause more

damage.

Step 1. To access the Hop Up Unit pull back the Charging Handle. The

Charging Handle can be pulled to either the Left or Right side.

Step 3. To adjust the hop up unit you will have to turn the wheel. Turning UP

will add more hop up effect and turning DOWN will turn the hop up unit off.

Once you find the best setting you can release the charging handle.

Step 2. To lock the Charging Handle back for an easier hop up adjustment

you can pull back and press down in the slot provided and lift up to release.

Only use Echo1USA BBs into your Echo1USA Airsoft Rifle. The use of .12g or

‘low grade’ BBs will damage your Airsoft Rifle and VOID the warranty.

The Hop Up Unit adds a back spin to the BB to allow a longer flight path.

Before use please do so in a safe location and make sure nobody is behind

the target. When using different weight BBs you will have to make adjust-

ments. When not is use please turn the Hop Up Unit off.

Turn Hop Up Unit OFF - Disconnect Battery - Remove Magazine

Cut the cloth or paper towel in the size as shown above. Fold the material to

fit through the loop. Adjust the length of the material to smoothly enter the

barrel. otherwise too much material will get jammed in the inner barrel and

can cause the hop up bucking to get out of place.

Step 1. Spray silicone oil into the hop up chamber from the wagwell for 1

sec. and fire 10-15 BBs to oil inner barrel and hop up parts.

Step 2. Fire 2 shots with magazine removed to clear gun of BBs and discon-

nect battery.

Step 3. With a twisting motion gently push the cloth and rod down the barrel.

Repeat 2-3 times until clean.

NOTE: You can apply silicone oil directly to the cloth as well.

If there is too much oil in barrel the BB trajectory will be unstable