Instruction Manual BEFORE USING THIS PRODUCT, CAREFULLY READ THOUGH MANUAL AND RETAIN IT FOR FUTURE REFERENCE. ECHO1USA AUTOMATIC ELECTRIC GUNS ARE INTENDED FOR AGES 18 AND ABOVE. THIS PRODUCT MAY CAUSE SERIOUS INJURY IS MISUSED. FULL FACE PROTECTION IS REQUIRED.
The Modular Tactical Carbine Series MTC 1 MTC 2 Specifications Specifications Weight Barrel Length Overall Length Barrel Caliber Ammo Capacity BB Size Feet Per Second Battery Type 7 lbs 247 mm 724 / 826mm 6.06 mm 300 rounds 6 mm 350-370 fps 9.6v Crane Type Weight Barrel Length Overall Length Barrel Caliber Ammo Capacity BB Size Feet Per Second Battery Type 7.5 lbs 247 mm 826 / 915 mm 6.06 mm 300 rounds 6 mm 350-370 fps 9.
Parts of the Gun Rear Sight Optic Rail Ambi Charging Handle Front Sight Hand Guard Pin RIS Rear Sling Loop Crane Stock Flash Hider Note: Removing or tampering of the flash hider will VOID the warranty 14mm CCW Magazine Release Magwell Pin Bolt Release Trigger Ambi Fire Selector Motor Set Screw Stock Pad Stock Adjustment Lever Castle Nut Stock Pin 3
Parts of the Gun (cont.
Ambi Fire Selection How to use the Magazine 1. Press the magazine release to remove the magazine from the gun. Mag Catch SAFE: Trigger is secure and cannot fire BB Entrance Top Hatch BB Stop Lever BB Exit SEMI: With one trigger pull one BB is fired Note: Avoid getting dirt and debris into the magazive this can cause it to malfunction. Only use Echo1USA BBs into your Echo1USA Airsoft Rifle. The use of .12g or ‘low grade’ BBs will damage your Airsoft Rifle and VOID the warranty. Magazine Wheel 2.
Battery Charging Charge the battery for 3 hours for the first time. When charging have the battery away from ALL COMBUSTIBLE MATERIALS and on a cool hard surface. If battery becomes HOT remove and charger and let it COOL before use. When cycle rate becomes slow, STOP shooting and remove the magazine. Shoot 2 times in SEMI to clear the gun, remove the battery and recharge. Basic Charge Time: Battery: 1500 mAh / Charger: 300mAh = Estimated Charge Time: 5 Hours Battery Installation Step 3.
Hop Up Unit Adjustment Hop Up Unit Cleaning / Unjam Gun The Hop Up Unit adds a back spin to the BB to allow a longer flight path. Before use please do so in a safe location and make sure nobody is behind the target. When using different weight BBs you will have to make adjustments. When not is use please turn the Hop Up Unit off. Turn Hop Up Unit OFF - Disconnect Battery - Remove Magazine Cut the cloth or paper towel in the size as shown above. Fold the material to fit through the loop.
Trouble Shooting Common Problems Solutions Gun is making a quiet clicking noise when trigger is pulled. Use a fully charged battery or 12v to unlock the gears. (http://www.youtube.com/watch?v=vwI4KG7fN00&feature=channel_ video_title) The trigger is stuck and will not pull back in SEMI. Switch the Selector to AUTO and fire 2-3 and switch back to SEMI. No power or noise coming from the gun. FUSE may be blown. Replace with a 20A or 25A FUSE found at most auto parts stores.
