MRF SERIES BEFORE USING THIS PRODUCT, CAREFULLY READ THOUGH MANUAL AND RETAIN IT FOR FUTURE REFERENCE. ECHO1USA AUTOMATIC ELECTRIC GUNS ARE INTENDED FOR AGES 18 AND ABOVE. THIS PRODUCT MAY CAUSE SERIOUS INJURY IS MISUSED. FULL FACE PROTECTION IS REQUIRED.
The TROY Series Before using this product, carefully read though manual and retain it for future reference. Echo1usa automatic electric guns are intended for ages 18 and above. This product may cause serious injury is misused. Full face protection is required. Specifications MRF-MX MRF-C MRF-S Weight 5.5 lbs 5.5 lbs 4.5 lbs Barrel Length 363 mm 247 mm 120 mm Overall Length 900/1000mm 685/785mm 570/670mm Barrel Caliber 6.06 mm 6.06 mm 6.
Parts of the Gun Charging Handle Outer Barrel Stock Adjustment Lever Magazine Release Hop Up Unit Dust Cover
Parts of the Gun TROY R.I.S.
Battery Charging Charge the battery for 3 hours for the first time. When charging have the battery away from ALL COMBUSTIBLE MATERIALS and on a cool hard surface. If battery becomes HOT remove and charger and let it COOL before use. When cycle rate becomes slow, STOP shooting and remove the magazine. Shoot 2 times in SEMI to clear the gun, remove the battery and recharge. Basic Charge Time: Battery: 1500 mAh / Charger: 300mAh = Estimated Charge Time: 5 Hours Battery Installation Step 3.
Ambi Fire Selection How to use the Magazine Avoid getting dirt and debris into the magazive this can cause it to malfunction. Only use Echo1USA BBs into your Echo1USA Airsoft Rifle. The use of .12g or ‘low grade’ BBs will damage your Airsoft Rifle and VOID the warranty. SAFE: Trigger is secure and cannot fire 1. Press the magazine release to remove the magazine from the gun.
Hop Up Unit Adjustment Hop Up Unit Cleaning The Hop Up Unit adds a back spin to the BB to allow a longer flight path. Before use please do so in a safe location and make sure nobody is behind the target. When using different weight BBs you will have to make adjustments. When not is use please turn the Hop Up Unit off. How to clean the inner barrel. Turn Hop Up Unit OFF - Disconnect Battery - Remove Magazine Cut the cloth or paper towel in the size as shown above.
Trouble Shooting Gun is making a quiet clicking noise when trigger is pulled. Use a fully charged battery or 12v to unlock the gears. The trigger is stuck and will not pull back in SEMI mode. Switch the selector to AUTO mode, fire 2 - 3 times, and switch to SEMI. No power or noise coming from the gun. Fuse may be blown. Replace with a 20 amp or 25 amp fuse found at most auto parts stores. Bypass by sticking the connectors together. Grindy / scratchy noise when shooting. Motor height is too high or low.
