Instruction Manual
Assembling the M28
Attaching the Bipod
To assemble the M28 you will have to open the box and pay special attention
to the part provided. We also have a video on our website on the M28
product page for the build process.
The bipod may look complex but it is not. The highlighted red
parts are the key parts.
Step 1. Locate the 3 screws and allen tool to assemble.
Step 2. The sling screw has a small hole in the cap. The middle screw is the
shorter all screw and the longer screw is for the back end of the rifle.
Operational Tip:
Make sure you evenly tighten the screws until hand tight. Over tightening or
uneven tightening may cause damage.
Make sure there is no packing material or loose parts in between the
sections as you tighten the screws.
This is the fake mag release and compartment. It has no function. The
highlighted red button is the release.
Step 1: Pull the locking pegs up and press onto the bipod lug. Make sure the
locking screw is loosened to allow movement.
Step 2: Tighten the locking screw to secure the bipod the to frame of M28.
Operational Tip: To make the M28 not rock back and forth make sure you
tighten the lean knob.
Locking Pegs
Lean Knob
Locking Screw
Leg Lock