Instruction Manual

Battery
Charge the battery for 3 hours for the first time. When charging have the
battery away from all combustible materials and on a cool hard surface. If
battery becomes hot remove and charger and let it cool before use. When
cycle rate becomes slow, stop shooting and remove the magazine. Shoot 2
times in semi to clear the gun, remove the battery and recharge.
Divide the battery output by the charger output to get the estimated charge
time for different battery / charger combinations.
Step 1. Gently push the stock pin to the side. The stock pin is held in the
stock by a small metal clip. With too much force aplied to the stock pin the
clip will become disconnected. Do not lose the stock pin and clip.
Step 2. Gently pull the wires out of the stock. On the wires there is the
fuse holder and the sockets. If the wires or fuse is nt plugged in the gun
will not function.
Step 3. The custom battery has an empty spot which is for the plug. Please
plug the battery in and place the wires as shown.
Step 4. Slide the battery and wires into the stock. The battery will slide all
the way in even when the stock is on the shortest position.
Step 5. Once the battery, wires and fuse is tucked into the stock you can
install the butt pad. Press the butt pad onto the back and press the stock pin
back through the holes to secure the pad onto the gun.
5
Socket
Plug
Fuse
Battery: 1200 mAh
Est. Charge Time:
4 Hours
=
Charger: 300 mAh
Socket
Fuse