User`s guide

2-4 Installing the PCLTA-20 Card
8. If the installation software discovers the SYSTEM.INI entry that loads the
ECHLMPA.386 ISA bus driver, it will comment out the entry and display the
following message, “SETUP has modified your SYSTEM.INI file by removing the
following entry: device=echlmpa.386.” It is not possible to use the ISA-bus protocol
analyzer card and the PCLTA-20 card on the same PC.
9. The installation software for the Windows 95/98/Me version will issue a prompt to
add a DOS virtual-mode device driver file named LDVVDD.SYS to the DOS
CONFIG.SYS file to support DOS applications calling LON1. This will allow DOS
applications to be used in a Windows 95/98/Me DOS shell/window. For more
information see Virtual-Mode DOS Driver later in this chapter. The following line
is added to the CONFIG.SYS file:
DEVICE=C:\LONWORKS\BIN\LDVVDD.SYS /D1
10. Software installation is complete. At the prompt to restart the computer, remove
the PCLTA-20 installation diskette and shut down the computer. Next insert the
PCLTA-20 into a PCI slot and turn the computer back on.
Windows NT 4 and Windows 2000 Software Installation Procedure
To install the PCLTA-20 software on a Windows NT 4 or Windows 2000 PC, follow the
instructions below. The PCLTA-20 software cannot be installed from DOS or a DOS
shell.
!
Only install the PCLTA-20 card after the software has been
installed.
1. Close all open programs.
2. Insert the installation diskette into the PC.
3. Open the Windows Start menu and select the Run command.
4. When prompted for a program name, enter the following:
a:SETUP.EXE
If necessary, replace a: with the drive letter which corresponds to the drive
containing the PCLTA-20 installation diskette.
5. When prompted with a list of languages, click on the desired language. A
checkmark will appear to the left of the language to be installed.