Specifications

LONWORKS® LN-Series Network Communication and Interface Guide Technical Bulletin38
Configuring the U/10 and U/20 Network Interface Properties
To configure the U/10 or U/20 network interface properties:
1. From the Start menu, select Settings > Control Panel. The Control Panel opens.
2. Double-click the LONWORKS Interfaces icon. The LONWORKS Interfaces
dialog box appears.
3. Click the USB tab (Figure 32).
4. Note the network interface name.
Note: Connect LN-Builder 3 to a remote network by configuring the Network
Connection Settings to the OnNet Management Mode and Network
Attached set to Yes. For instructions on configuring these settings, refer to
the Defining Network Connection Settings section of the LN-Builder 3
Technical Bulletin (LIT-12011250).
Figure 32: LONWORKS Interfaces Dialog Box —
USB Tab