Specifications

LONWORKS® LN-Series Network Communication and Interface Guide Technical Bulletin 33
Configuring the i.LON 600 LONWORKS/IP Server IP Address
To configure the i.LON 600 LONWORKS/IP Server IP address:
1. Connect your computer directly to the i.LON 600 server using an Ethernet
cable.
2. To communicate with the i.LON 600 server, verify that your computer is on the
same subnet as the i.LON 600 server, which is 192.168.1.x. If the computer’s
subnet is different, open a DOS command prompt and type in the following
command: route add 192.168.1.0 mask 255.255.255.0 %computername%
3. Open your Internet browser and enter the following address:
http://192.168.1.222/config/
4. From the Setup tab of the i.LON 600 LONWORKS/IP Server screen,
select TCP/IP.
5. Set the user name to ilon and the password to ilon. The TCP/IP setup screen
appears (Figure 27).
6. Set the TCP/IP parameters.
7. Click Submit when the configuration is complete.
Note: These parameters take effect after you power cycle to the i.LON 600
server.
Figure 27: i.LON 600 LONWORKS/IP Server Screen