Specifications

LONWORKS® LN-Series Network Communication and Interface Guide Technical Bulletin30
2. Perform a security access reset on the i.LON 100 server to reset the IP address
to the default value and enable other features:
a. Disconnect the power adapter of the i.LON 100 server.
b. Press and hold the service pin switch of the i.LON 100 server.
c. Reapply power to the i.LON 100 server while continuing to hold the
service pin until all of the LEDs illuminate (10 seconds).
Note: When the LEDs illuminate, it means that the security access reset has
been performed properly.
3. To communicate with the i.LON 100 server, verify that your computer is on the
same subnet as the i.LON 100 server, which is 192.168.1.x. If the computer’s
subnet is different, open a DOS command prompt and type in the following
command: route add 192.168.1.0 mask 255.255.255.0 %computername%
4. Open your Internet browser and enter the following address:
http://192.168.1.222/
5. Click Service. A logon dialog box appears.
6. Set the user name to ilon and the password to ilon.
7. Click the Setup tab and select TCP/IP. The LAN/WAN setup page appears
(Figure 23).
8. Set the TCP/IP parameters.
9. Click Submit when the configuration is complete.
Note: These parameters take effect after you power cycle to the i.LON 100
server.
Figure 23: i.LON 100 e.3 Internet Server Properties Screen — LAN/WAN