Specifications

LONWORKS® LN-Series Network Communication and Interface Guide Technical Bulletin 29
Note: Connect LN-Builder 3 to a remote network by configuring the Network
Connection Settings to the OnNet Management Mode and Network
Attached set to Yes. For instructions on configuring these settings, refer to
the LN-Builder 3 Technical Bulletin (LIT-12011250).
i.LON 100 Internet Server
Note: The i.LON 100 Internet Server is the predecessor to the i.LON
SmartServer.
The i.LON 100 e.3 Internet Server bridges LONWORKS networks and can be used
as an interface that connects LONWORKS based devices to the Internet, a LAN, or a
WAN. As an option, this adapter can be used with a modem for dial-up
connectivity. This section briefly describes how to set up the i.LON 100 e.3
Internet Server and use it as a Remote Network Interface (RNI). See the Network
Interfaces section for a description of this network interface. For more information
about this network interface, refer to the i.LON 100 e.3 Internet Server User’s
Guide.
Installing the i.LON 100 e.3 Internet Server
To install the i.LON 100 e.3 Internet Server:
1. Insert the i.LON 100 e.3 Internet Server installation CD into your computer.
Note: If the installation wizard fails to start, browse through the CD and
double-click setup.exe.
2. Follow the instructions in the installation wizard.
Note: After the setup is complete, visit the Echelon Web site to download
software updates at: http://www.echelon.com/downloads
Configuring the i.LON 100 e.3 Internet Server IP Address and
Security Settings
To configure the i.LON 100 e.3 Internet Server IP address and security settings:
1. Connect your computer directly to the i.LON 100 server using an Ethernet
cable.
Figure 22: i.LON 100 e.3 Internet Server