Specifications

LONWORKS® LN-Series Network Communication and Interface Guide Technical Bulletin26
i.LON 10 Ethernet Adapter
The i.LON 10 Ethernet Adapter is an interface that connects LONWORKS based
devices to the Internet, a LAN, or a WAN. There are multiple steps required to
configure an i.LON 10 Ethernet Adapter. This section briefly describes how to set
up the i.LON 10 adapter and use it as a Remote Network Interface (RNI). See the
Network Interfaces section for a description of this network interface. For more
information about this adapter, refer to the i.LON 10 Ethernet Adapter User’s
Guide.
Installing the i.LON 10 Ethernet Adapter
Note: The i.LON 10 Ethernet Adapter is an obsolete product.
To install the i.LON 10 Ethernet Adapter:
1. Insert the i.LON 10 Ethernet Adapter installation CD into your computer.
Note: If the installation wizard fails to start, browse through the CD and
double-click setup.exe.
2. Follow the instructions in the installation wizard.
Note: After the setup is complete, visit the Echelon Web site to download
software updates at: http://www.echelon.com/downloads
Configuring the i.LON 10 Ethernet Adapter IP Address and Security Settings
To configure the i.LON 10 Ethernet Adapter IP address and security settings:
1. Connect your computer directly to the i.LON 10 Ethernet Adapter using a
crossover cable.
2. Perform a security access reset on the i.LON 10 Ethernet Adapter to reset the
IP address to the default value and enable other features:
a. Disconnect the power adapter of the i.LON 10 Ethernet Adapter.
b. Press and hold the service pin switch of the i.LON 10 Ethernet Adapter.
Figure 18: i.LON 10 Ethernet Adapter