User`s guide

PCLTA-21 PCI Interface User’s Guide
23
Service
!
The Service button is not available if you are using the PCLTA21VNI image. If
you are using the PCLTA21VNI image, first select the PCLTA21NSI image,
click Apply, click the Service button, then reselect the PCLTA21VNI image, and
click Apply.
The Service button will cause the PCLTA-21 card to broadcast a service pin
message on the network. The service pin message will not be sent if the card is
in the post-reset flush state (see Automatic Flush Cancel).
Restart
The Restart button clears the card’s Neuron Chip image and places the
device into the boot state. This is the device state found following a re-boot
of the Windows operating system. When this function is chosen a dialog
will appear asking for confirmation of this command.
Reset
The Reset button causes a reset of the card’s Neuron Chip, but does not
clear its Neuron Chip image.