User`s guide

PCLTA-21 PCI Interface User’s Guide

parameter you would access the 9th device, as determined by the /D9

option. These options are typically needed when more than one

ONWORKS network interface is present in the system.

PCLTA-21 Card Hardware Installation

ESD Warning

This product contains devices which are sensitive to static electricity.

Before installing or removing the PCLTA-21 card or the network

cables, discharge any static electricity which may have accumulated

to earth ground by touching the case or power supply.

1. Turn off the PC and remove the power cord.

2. Open the PC case and locate an empty PCI slot. The PCLTA-21 is a Universal

card that will work in 3.3V, 5V, 32-bit, and 64-bit PCI slots. Remove the

corresponding blank panel from the rear of the PC. Set aside the screw.

3. Insert the PCLTA-21 card into the slot, ensuring that the edge

connectors are fully mated and the slot in the rear panel mounting lug

of the PCLTA-21 card is aligned with the threaded hole in the PC

chassis.

4. Replace the screw to hold the PCLTA-21 card firmly in place.

5. Reinsert the power cord and then restart the PC. A New Hardware

Found window will be displayed briefly when Windows recognizes the

PCLTA-21 card.

Changing to the Low Profile Bracket

If the PCLTA-21 is too tall to fit inside your computer’s enclosure, you can

change to the low profile bracket that is shipped in the PCLTA package.

To change brackets:

1. Using a Philips screwdriver, remove the two screws securing the

standard bracket to the PCLTA-21 circuit board.

2. Remove the low profile bracket from the PCLTA-21 package.

3. Align the low profile bracket to the PCLTA-21 circuit board and re-

attach using the same two screws.