User`s guide

3-4 Configuring and Testing the PCLTA-20 Adapter
no PCLTA-20 adapter currently installed in a PCI-bus slot, a message appears
stating that the operating system has removed, or has not loaded, the PCLTA-20
device driver.
Figure 3.3 PCLTA-20 Transceiver dialog box
The Transceiver selection box specifies the transceiver type for the selected PCLTA-
20 adapter. The default transceiver is an FT-10-compatible transceiver. Other
standard transceiver configurations, and a custom configuration, may be chosen
using this selection box. The Custom Properties controls are not accessible unless
the Custom transceiver type is selected: you cannot modify the transceiver type as it
is a product of the XID, however, if the XID is custom then you can modify the fields
using the Custom Properties dialog box. If an incorrect transceiver type error is
received while modifying the transceiver type, choose the Apply button, then proceed
to modify the transceiver type.
The Custom Properties area contains controls for entering custom transceiver
properties. The information in this area reflects the current configuration within
the PCLTA-20 adapter. It will not change until a transceiver is selected, and then
configured using the OK or Apply buttons.
When configuring a custom transceiver or adding custom parameters for a standard
transceiver, the values used in the Custom Properties Raw Data edit boxes must be
entered as hexadecimal values separated by dashes. Further explanation of Raw
Data values can be found in the
LonBuilder
®
User’s Guide
2
.
Diagnostics...
Opens the PCLTA-20 Diagnostics dialog box. For more information, see the section
on PCLTA-20 Diagnostics.