User`s guide

PCLTA-20 Adapter User’s Guide 2-5
9. Software installation is complete. At the prompt to restart the computer, remove
the PCLTA-20 installation diskette, turn off power, install the PCLTA-20, and
then reboot the computer.
Software Installation Results
The installation software for the PCLTA-20 adapter loads a selection of new files and
updated versions of existing files to different locations on the PC’s hard drive. The
function and location of these files can be found in the on-line help file.
Windows 95/98 Software Removal Procedure
To remove the PCLTA-20 software, use the Uninstall control panel, as follows:
1. Choose the Add/Remove Programs icon from the Control Panel folder.
2. Select “LonWorks
®
PCLTA-10/20/PCC-10 for Windows® 95/98” from the list
under the Install/Uninstall tab.
3. Click the “Add/Remove...” button.
4. Confirm file deletion at the prompt. Most of the PCLTA-20 software will be
removed automatically.
5. If necessary, edit the
CONFIG.SYS
file to remove any references to the stub
driver.
Windows NT Software Removal Procedure
To remove the PCLTA-20 software under Windows NT 4.0 or later, use the Uninstall
control panel, as follows:
1. Choose the Add/Remove programs icon from the Control Panel folder.
2. Select “LonWorks
®
PCLTA-10/20/PCC-10 for Windows® NT” from the list under
the Install/Uninstall tab.
3. Click the “Add/Remove...” button.
4. Confirm the deletion at the prompt. Most of the PCLTA-20 software will be
removed automatically.
5. If necessary, edit the
CONFIG.NT
file to remove any references to the
PCLTADOS.SYS
driver.
To remove the PCLTA-20 software under Windows NT 3.51, remove all files that
were created during installation. See Windows NT Installation Results in the help
file for a list of these files and their locations.