User`s guide

4-4 Electrical Interface
card’s network port and table 4.2 describes the electrical characteristics of the
card’s digital inputs and outputs.
Table 4.1 PCC-10 Network Port Electrical Interface Description
Pin Signal Type Description
1 ~Pod_Sense Digital Input Pod Connection Indicator
2 ~Drive_Pod_Reset Digital Output Reset Line for External Transceiver
3 ~Sense_Pod_Reset Digital Input External Tranceiver Reset Indicator
4 no conn No connection
5 Buf_CP4 Digital
Input/Output
Buffered Neuron Chip CP4 Line
6 Buf_CP3 Digital
Input/Output
Buffered Neuron Chip CP3 Line
7 Buf_CP2 Digital Output Buffered Neuron Chip CP2 Line
8 Buf_CP1 Digital Output Buffered Neuron Chip CP1 Line
9 Buf_CP0 Digital Input Buffered Neuron Chip CP0 Line
10 Vcc Power Output +5V
DC
supply*
11 Vcc Power Output +5V
DC
suupply*
12 GND Shield Ground
13 GND Shield Ground
14 FT_NetB FT-10 Network FT-10 Network Connection B
15 FT_NetA FT-10 Network FT-10 Network Connection A
* Note: the +5V
DC
supply is generated by the host and is electronically current-
limited by the PCC-10 card to approximately 600mA.