User`s guide

3-6 Configuring the PCC-10 Card
setting of Layer2 Buffering is 20 pages, and the default setting of Layer6 Buffering
is 6 pages. These values should be appropriate for most applications; embedded
systems may need to change the number of buffering pages.
Enable PC Card Reset
This switch controls whether the PCC-10 card’s PC Card hardware reset line is
enabled. With the reset line enabled, the PCC-10 card operates in full compliance
with the PCMCIA PC Card Standard, Release 2.1. However, this mode of
operation reduces the card’s resistance to electrostatic discharge (ESD) by making
it susceptible to spurious resets introduced on the reset line by the host PC.
Disabling the reset line provides the full ESD resistance, without
otherwise affecting card performance.
The default setting is unchecked, i.e., the PC Card reset is disabled.
PCC-10 Diagnostics
A number of diagnostic and testing services are provided by the PCC-10 control
panel. Clicking the Diagnostics button in the main control panel window displays
the PCC-10 Diagnostics dialog. This dialog contains buttons for the diagnostic
commands and displays the version number and current status of the PCC-10
device driver. If no PCC-10 card is inserted in a PC Card slot, the Diagnostics
window will display “(no driver found)” under Windows 95 or “no device installed”
under Windows 3.1x. To display the driver information, insert a PCC-10 card,
close the window by selecting the OK button, then re-open the Diagnostics window.