User`s guide

PCC-10 User's Guide 3-5
The PCC-10 card will be configured for the selected transceiver when either the OK
button or Apply button is chosen. While either button will configure the PCC-10
card, the OK button will also close the PCC-10 Transceiver window. To implement
the changes, the PCC-10 card will reset whenever the transceiver configuration is
changed.
The information in the Custom Properties area reflects the current configuration
within the PCC-10 card. It will not change until a transceiver is selected, and then
configured by using the OK or Apply buttons.
When configuring a custom transceiver or adding custom parameters for a
standard transceiver, the values used in the Custom Properties Raw data edit
boxes must be entered as hexadecimal byte values separated by dashes. Further
explanation of Raw data values can be found in the LonBuilder
¨
User’s Guide
5
.
Diagnostics...
This setting opens the PCC-10 Diagnostics dialog box. For more information, see
the section on PCC-10 Diagnostics.
General Settings
The PCC-10 generic options consist of four controls (figure 3.8). These controls are
defined as follows:
Figure 3.8 PCC-10 generic controls
System Image Path
This control specifies the full directory path for the PCC-10 system images. This
path is set by the PCC-10 Installation Software but may be modified by the user.
Layer2 and Layer6 Buffering
This setting controls the number of 4Kbyte operating system pages that are
allocated for message buffering within the driver. The Layer2 setting is used by
the LonManager PCC-10 Protocol Analyzer only and generally should not be
modified. The Layer6 setting is used for all other system images. The default