User`s guide

3-4 Configuring the PCC-10 Card
NI Application
This setting controls the type of image or application to be used. (When using the
LonManager Protocol Analyzer software with the PCC-10 Protocol Analyzer card,
this selection is handled automatically.) A PCC-10 card can only hold one image at
a time. Loading a new image will replace the currently loaded image. The choices
for these images are determined by the image files (.NBI extension) found in the
system image path specified under General Settings. Some of the possibilities
include the following:
• PCC10L7, the basic network interface application image
• NSIPCC, the Network Services Interface application image
Transceiver...
This control opens the PCC-10 Transceiver dialog box (figure 3.3). Choosing this
control will retrieve the transceiver configuration of the selected PCC-10 card. If
there is no PCC-10 currently inserted in a PC Card slot, a message appears under
Windows 95 stating that the operating system has removed, or has not loaded, the
PCC-10 device driver. Under Windows 3.1x, the message states that no inserted
card is found.
The default transceiver is an FT-10-compatible transceiver that is built into the
PCC-10 card. Other standard transceiver configurations and a custom
configuration may be selected using the Transceiver selection box. The Custom
Properties controls are not accessible unless the Custom transceiver type is
selected. If an error is received while modifying the Transceiver type, choose the
Apply button, then proceed to modify the Transceiver type.
Figure 3.3 PCC-10 Transceiver Dialog Box