User`s guide

3-2 Configuring the PCC-10 Card
PCC-10 Configuration
PCC-10 card configuration is accomplished using the L
ON
W
ORKS
PCC-10 control
panel. Open the control panel by selecting the “LonWorks
¨
Plug ‘n Play” icon in the
Control Panel folder located in the My Computer folder on the Windows 95
Desktop, or in the Program Manager’s Main folder under Windows 3.1 or 3.11.
There is no Control Panel for the MS-DOS PCC-10 Device Driver. Configuring a
PCC-10 Card for use with the DOS driver must be done after installation. Details
of how to configure the PCC-10 Card for use with the DOS driver can be found in
the Installation section. Testing of the PCC-10 Card can be performed using the
NODEUTIL.EXE utility which is available in the Developers Toolbox at the Echelon
web site at www.echelon.com.
Figure 3.1 Plug ‘n Play Icon and Control Panel for the PCC-10 Card
The L
ON
W
ORKS
PCC-10 control panel is divided into three parts: a device selection
area, a general settings area, and a control section. The device selection area
contains configuration settings and diagnostic controls that are specific to an
individual PCC-10 card and its device driver. The general settings area contains
settings for all PCC-10 cards used with the computer. The control section contains
buttons for accepting or canceling the changes made in the control panel, as well as
a Help button.