User`s guide

PCC-10 User's Guide 2-15
If cancel or an option other than Windows default driver is chosen, follow the
instructions indicated for that selection below:
Cancel
If the Cancel button is accidentally selected, remove the PCC-10 card and re-insert
it. This action will cause the New Hardware Found window to be displayed again.
Choose the Windows default driver.
Do not install a driver
If this option is chosen, the PCC-10 software must be re-installed to use the PCC-10
card. This screen will only be presented once.
Driver from disk…
Do not select this option. If this option is selected inadvertently, a prompt will ask
for a diskette containing the driver. Since the PCC-10 software installation
diskette does not include the driver in a readable form, no driver will be found. In
this case, cancel the request, remove the PCC-10 card, and re-insert it. This will
cause the New Hardware Found window to be displayed again. Choose the
Windows default driver.
Select from a list…
Do not select this option. If this option is selected inadvertently, a list of drivers is
displayed which does not contain the required driver. In this event, cancel the
request, remove the PCC-10 card, and re-insert it. This action will cause the New
Hardware Found window to be displayed again. Choose the Windows default
driver.
Troubleshooting
As a “plug and play” type device, the PCC-10 PC Card should operate as desired
following completion of the installation process. If the PCC-10 card does not
function correctly, the most likely causes are system resource constraints or
software incompatibilities. These problems are described in detail in the following
sections.
Windows 95 has some limitations regarding Card & Socket Services. Intel, Vadem,
IBM DataBook, Compaq, Maxtor, Cirrus are among the socket controller
companies that are supported by Windows 95: not all controllers from all
manufacturers are supported by Windows 95.