User`s guide

2-12 Installing the PCC-10 Card
3. Within the enclosed \BIN subdirectory, delete the following files:
LDVSTUB.SYS
LONCSM.EXE
LONPCC10.386
4. Within the \IMAGES subdirectory, remove the \PCC10 directory and its
contents.
5. At the root drive level (default: C:\ ), edit the CONFIG.SYS file to remove any
references to the LDVSTUB.SYS driver.
6. From within the \WINDOWS directory, edit the SYSTEM.INI file to remove any
references to LONPCC10.386.
7. If no other L
ON
W
ORKS
-based products are present on the computer, the
WLDV.DLL file may be deleted from the Windows System (default:
c:\windows) directory. If other L
ON
W
ORKS
-based products are present, the
WLDV.DLL file may be required to use those products, and therefore should
remain in the Windows directory.
DOS Software Removal Procedure
To remove the PCC-10 software, open the CONFIG.SYS file with a text editor.
1. Remove any “DEVICE=” references to LDVVDD.SYS, LDVPCC10.SYS, and
LDVPCC10.INI.
2. Reboot the computer.
3. If no Windows version of the PCC-10 Device Driver is installed on the
computer, then delete the \PCC10 directory and its contents from the \IMAGES
directory in the main directory in which the PCC-10 was installed, i.e.,
DELTREE \LONWORKS\IMAGES\PCC10 [RETURN]
If a Windows version of the PCC-10 Device Driver does exist, then remove the
README.TXT file from the \IMAGES\PCC10 directory.
4. Delete LDVVDD.SYS, LDVPCC10.SYS, and LDVPCC10.INI from the \BIN
directory (i.e., C:\LONWORKS\BIN).
PCC-10 Card Hardware Installation
If the software has not been installed, please read the earlier section titled PCC-10
Software Installation. The Windows operating system will not recognize the
PCC-10 card without the software installed.
The PCC-10 card conforms to the Personal Computer Memory Card International
Association’s (
PCMCIA
) standard for hot plug-in. The PCC-10 card will not be
harmed if it is inserted into, or removed from, a PC Card (
PCMCIA
) slot which