User`s guide

PCC-10 User's Guide 2-11
Software Installation Results
The installation software for the PCC-10 Card loads a selection of new files and
updated Echelon files to different locations on the PC’s hard drive.
For Windows installations, the function and location of the files can be found in the
on-line help file.
For DOS installations, see the section entitled MS-DOS Software Removal
Procedure in this manual.
Windows 95 Software Removal Procedure
To remove the PCC-10 software, use the Uninstall control panel, as follows:
1. Close the “LonWorks
®
Plug ‘n Play” control panel if it is open.
2. Choose the Add/Remove Programs icon from the Control Panel folder.
3. Select “LonWorks
®
PCC-10” from the list under the Install/Uninstall tab.
4. Click the “Add/Remove...” button.
5. Confirm file deletion at the prompt. Most of the PCC-10 software will be
removed automatically.
6. The “LonWorks
®
Plug ‘n Play” control panel must be removed manually. Close
the Control Panel folder if it is open. Rename C:\Windows\System\
Pcc10cfg.cpl to C:\Windows\System\Pcc10cfg.cpx, (where C: is the
drive containing the Windows folder) then remove the file Pcc10cfg.cpx by
placing it in the Recycle Bin. It is not nessessary to empty the Recycle Bin at
this time.
Windows will not allow deletion of Pcc10cfg.cpl because it is registered as a
control panel. Renaming the file circumvents this Windows 95 restriction.
7. If necessary, edit the CONFIG.SYS file to remove any references to the
LDVSTUB.SYS driver.
Windows 3.1 and 3.11 Software Removal Procedure
To remove the PCC-10 software, use the File Manager or DOS command line to
delete the PCC-10 software from the PC, as follows:
1. Close the “LonWorks
®
PCC-10 Card Manager” if it is open.
2. Open the directory in which the software was installed, i.e., c:\LONWORKS.