User`s guide

2-2 Installing the PCC-10 Card
PCC-10 Card Software Installation
!
Installation of the PCC-10 software must precede insertion of
a PCC-10 card into a PC Card (
PCMCIA
) slot.
Failure to install the software before inserting the card will
render the card unusable until the software is removed, and
then reinstalled.
The six steps of the installation process are as follows:
1. Install Windows PCMCIA driver if not currently installed. A Windows
PCMCIA
driver must be installed prior to PCC-10 card installation. Under
Windows 95, the PC Card driver is installed automatically when the PC
Card drive is installed. (If this driver is not present, please consult the
Windows 95 documentation.) Under Microsoft DOS, Windows 3.1 and
Windows 3.11, the PC Card driver must be installed manually. If the
driver has not been installed, please consult the PC Card drive
manufacturer’s documentation and install the PC Card driver before
continuing.
2. If you have purchased the LonManager PCC-10 Protocol Analyzer, install
the protocol analyzer applications following the instructions provided in
the LonManager Protocol Analyzer User’s Guide
3
. Note that you cannot
use the LonManager ISA Protocol Analyzer card and a PCC-10 card in the
same PC.
3. Install the PCC-10 driver software as described below.
4. Insert the PCC-10 card, as described later in this chapter.
5. Attach cable/pod.
6. Install the L
ON
W
ORKS
Network Services (LNS) software, if used.
Note: If the LonManager Protocol Analyzer software is installed after installing
the PCC-10 card software, the PCC-10 card software must be re-installed.