Owner manual

OpenLNS Programmer's Reference 809
the following format:
FM:MM:MM:CC:CC:UU:TT:NN
Note: You may not use colons when writing the program ID.
For a device with a program ID of 80:00:01:01:28:80:04:02,
you can write 8000010128800402 in this property.
See the Devices Interfaces section in the OpenLNS
Programmer’s Guide for a description of the format used to
display program IDs.
Availability
Local, full, and lightweight clients.
Syntax
programIdValue = object.ProgramId
Element
Description
programIdValue
The program ID value of the object.
object
The object to be acted on.
Data Type
String.
Read/Write
Read/write.
Added to API
Prior to LNS Release 3.0.
State
Summary
Describes the state of a router side.
You cannot set the state of a router side in the same
transaction as an Add, Commission, or Replace method. You
cannot set the state of a router side during the definition
phase of the predefined components installation scenario.
The state change may fail if the router side has not been
completely updated due to a previous communication
problem or if the router side has not been commissioned. If a
failure occurs, use the Commission method to force an update
of the router side.
Router sides are placed offline while they are being
configured or commissioned.
Availability
Local, full, and lightweight clients.
Syntax
stateValue = object.State
Element
Description
stateValue
The state of the router side (online or
offline). The enumerated values for
this property, which are stored in the
ConstDeviceStates constant, are as
follows:
Note: The only two values that may
be written to this property are
lcaStateCnfgOnline(4) and
lcaStateSoftOffline(12). All other