Owner manual

ManualsBrandsEchelon ManualsSoftwareOpenLNS

OpenLNS Programmer's Reference 436

3 lcaLonMarkObjectRequestSelfTest

Performs a self-test on the object. The

SelfTestResults property of the

LonMarkObject will be updated to reflect

the results of the test.

4

lcaLonMarkObjectRequestUpdateAlarm

Updates the alarm status of the

LonMarkObject. In this case, the

LonMarkAlarm property of the

LonMarkObject will be updated to reflect

the current alarm status of the

LonMarkObject on the network.

5

lcaLonMarkObjectRequestReportMask

Reports the status bit mask of the

LonMarkObject. In this case, the

ReportMask property of the LonMarkObject

will be updated with current information.

6 lcaLonMarkObjectRequestOverride

Overrides the LonMarkObject.

7 lcaLonMarkObjectRequestEnable

Enables the LonMarkObject.

8

lcaLonMarkObjectRequestRemoveOve

rride

Cancels an override of the LonMarkObject,

without changing the enabled/disabled state

of the LonMarkObject. You can initiate an

override by writing the

lcaLonMarkObjectRequestOverride (6)

value to the Request property. You can

cancel an override, and re-enable the

LonMarkObject, by writing the

lcaLonMarkObjectRequestNormal (0)

value to this property.

9

lcaLonMarkObjectRequestClearStatus

Clears the status of the LonMarkObject. In

this case, the information contained in the

Status property of the LonMarkObject will

be cleared.

10

lcaLonMarkObjectRequestClearAlarm

Clears the alarm state of the

LonMarkObject. The information contained