Owner manual

OpenLNS Programmer's Reference 995
May not send implicit tags via NI layer. Must use a message monitor point.
lcaErrNiUnimplemented 27
This is an internal error and should be reported to customer support.
lcaErrNiBufferSize 28
The message length is too long.
lcaErrNiNoMessages 29
Message not found.
lcaErrNiNegativeResponse 30
Negative response.
lcaErrNiStateError 31
Unable to change the state of the network interface.
lcaErrNiReadBusy 32
Previous response messages have not been read.
lcaErrNiMaxInterfacesOpen 33
There are no network interface resources available.
lcaErrNiInvalidNiHandle 34
Invalid network interface resource.
lcaErrNiOpenNiDeviceMismatch 35
The network interface has already been opened with a different network driver. This
error will be generated if you open a network that is already opened using a different
network interface, NSS type, or database directory
lcaErrNiNoWinsockDll 36
OpenLNS attempted to use IP without the winsock.dll file installed.
lcaErrNiCantOpenIpLink 37
An OpenLNS network interface failed to open an IP connection.
lcaErrNiInvalidIpAddress 38
An OpenLNS network interface uses an IP address not defined on this PC.
lcaErrNiDeviceOpenFailure 39
Device driver open failure
lcaErrNiNoMoreLeft 40
Signal iteration complete
lcaErrNiMipInUse 41
If using a regular OpenLNS network interface (a non-high-performance network
interface), only one network may be opened at a time. This error will be returned if you
attempt to open a second network.