Owner's manual
7-4 Installing the DO-10 Digital Output
Module
The DO-10 module is installed in a Type 1 or Type 1D Base Plate. Wiring connections
to the DO-10 module are presented in table 7.1. Specifications for the DO-10 module
are shown in table 7.2.
Table 7.1 DO-10 Digital Output Module Wiring Connections
Screw Terminal Wiring Connection
1 and 2 Incoming network wiring, TP/FT-10 channel, polarity-
insensitive
3 and 4 Outgoing network wiring, TP/FT-10 channel, polarity-
insensitive
5 Unused
6 and 7 Incoming power wiring, 16-30VAC or VDC, 3.2 to 6.5VA
depending on load maximum, polarity-insensitive. If using DC
power, it is good practice to maintain continuity of the power
polarity throughout the network. Terminals 6 and 8 should be
the same polarity, and terminals 7 and 9 should be the same
polarity.
10 + output of digital output 1
11 - output of digital output 1 (common to all outputs)
12 + output of digital output 2
13 - output of digital output 2 (common to all outputs)
14 Unused
15 + output of digital output 3
16 - output of digital output 3 (common to all outputs)
17 + output of digital output 4
18 - output of digital output 4 (common to all outputs)
Table 7.2 LonPoint DO-10 Digital Output Module Specifications
Function Description
Processor/memory Neuron 3150 Chip, 10MHz, 56K flash memory
Service function Recessed service switch, service LED, power/wink LED. Dual
tear-off bar-code Neuron ID self-adhesive tag for application to
red-line drawings in the field
I/O 4 digital outputs, 0-12V, 100mA source/sink maximum on any
one output, 110mA source/400mA sink combined; separate
status LEDs for each output; separate hand/off/auto front
panel DIP switches for each output
I/O isolation 100V, transformer isolation. Outputs are isolated from the input
power and the network but not from each other.
Transceiver type FTT-10A with blocking capacitors for compatibility with link
power channel
Network connector Phone plug connector accessible from front panel
Input power 16-30VAC or VDC @ 3.2 to 6.5VA depending on load,
internally isolated power supply
Mounting Type 1 or Type 1D Base Plate
Temperature -40 to +85°C, operating and non-operating
Humidity 10 to 95% RH @ 50°C