User Manual

Section 3: Appendixes
Figure 49. Add LONWORKS/IP Device Dialog
5. Fill in the following information:
Name The name of the LONWORKS/IP device.
IP Address The IP address of the device will be automatically set to the PC’s IP
address (if the PC has multiple Ethernet cards with different IP
addresses, you may select the specific address you want to use).
IP Port The port that the PC communicates with other LONWORKS/IP
devices. By default, this is 1628.
Authentication Key If the LONWORKS/IP channel will be set up to use MD5
authentication, enter the 16 pair hexadecimal authentication key in
this field.
6. Click OK. The control panel will now look as shown in Figure 50
.
102 Using Your i.LON 600 as a Remote Network Interface