User Manual

Installing the i.LON 600 PC Software
To install the i.LON 600 Software, follow these steps:
1. Insert the i.LON 600 CD-ROM into your PC and follow the instructions in the Setup
Wizard. If the installation program fails to start, navigate to your CD-ROM and
double click setup.exe in the root directory.
2. Make sure you have Internet Explorer 6, SP 1 (or later) installed on your computer.
This is available on the i.LON 600 CD-ROM in the following location:
\IE\ie6setup.exe
Note: The i.LON 600 Configuration Server can open i.LON 1000 Configuration Server
databases. You cannot, however, re-open the databases with an i.LON 1000
Configuration Server.
i.LON 600 Setup Overview
To begin using the i.LON 600, you must:
1. Connect the i.LON 600 Hardware – This includes connecting the
i.LON 600 to a power source, L
ONWORKS network, and an Ethernet network.
!
WARNING
Connecting the i.LON 600 (models 72601 and 72602) to a power source involves
handling high-voltage wiring and must be performed by a qualified service person.
2. Configure the i.LON 600’s IP information – This includes configuring the IP
address, host name, etc. using the i.LON 600 setup Web pages or console
application.
3. Setup a L
ONWORKS/IP channel using the Configuration Server.
4. Add the i.LON 600 to a LONWORKS Network – Using the LonMaker tool, drag a
router shape from the stencil to the LonMaker drawing, and then provide the Neuron
ID of the i.LON 600 using either the service pin or manual entry. Figure 1 shows a
flowchart of the i.LON 600 setup.
i.LON 600 User’s Guide 3