Services 2.0

Echelon Enterprise Services 2.0 User’s Guide 29
Upgrading the SmartServer Firmware
You can use the i.LON AdminServer to upgrade the firmware on SmartServers running the Release 4,
4.01, or 4.02 firmware (SmartServer 1.0) and i.LON e3 plus Servers to the Release 4.03 firmware
(SmartServer 2.0). You can also use the i.LON AdminServer to upgrade your SmartServers later as
SmartServer 2.0 service packs are made available.
Notes:
• To upgrade i.LON e3 plus Servers or SmartServers that have previously been downgraded to the
i.LON 100 e3 version firmware to the SmartServer 2.0 (Release 4.03) firmware, you must first
manually upgrade them to the SmartServer 1.0 (Release 4.02) firmware via FTP as described in
Chapter 3 of the i.LON SmartServer 2.0 User’s Guide.
• You can upgrade a SmartServer that is set to its default IPv4 address, which is 192.168.1.222.
• The upgrade process preserves all IP-852 routing and programming licenses on your i.LON
servers.
• The i.LON AdminServer does not upgrade the bootrom on the SmartServer. You need to
manually upgrade the bootrom following the steps described in Updating the Bootrom in
Appendix B of the i.LON SmartServer 2.0 User’s Guide.
To upgrade the firmware on your SmartServer to the latest version, follow these steps:
1. Verify that you have installed the latest i.LON SmartServer software. This installs the current
SmartServer image on your EES 2.0 computer. See Chapter 2 of the i.LON SmartServer 2.0
User’s Guide for more information on installing the SmartServer products.
2. Expand the Upgrades folder to display the SmartServer image installed in the
LonWorks\iLON\EnterpriseServices\repository\com\echelon\ilon\ilon_image\4.03.<minor
version number> folder on your computer.
3. Right-click the SmartServer image and then click Install on the shortcut menu.