User Manual

10
ASSEMBLY
Untie the twist tie at top of handlebar
post, ensuring not to allow the wire to
fall inside of handlebar post. Connect
the wire from the handlebar post to
the wire at bottom of tablet mount.
Place handlebars onto handlebar
post. Secure with handlebar
adjustment lever.
Connect the two wires from frame
and handlebar post together, then
feed excess wire down into frame.
Insert handlebar post screw into
hole on post. Use small hex key to
tighten. Ensure holes in handlebar
post and handlebar post frame align
properly before inserting screw.
Unscrew handlebar height
adjustment lever, but do not
remove. Pull lever out and fully
insert handlebar post into frame.
Release lever and post is secure.
Feed excess wire into handlebar
post and slide tablet mount into
handlebar post. Secure with tablet
mount bolts with flat washers.