Owner's manual

4-4 Device Manager Hardware Description and Installation

Pin Description

The DM-20 module has a single 2x7 connector. The pinout is described in table 5.2.

Table 4.2 DM-20 Pinout

JP1 2x7

Connector Pin

Number

DM-20 Module

Signal Type

Description

1 FTT-10A Net1

2 +5V DC Power input +5V±5% input @ 150

3 FTT-10A Net2

4 Ground Ground

5 Not used

6 Neuron ~Service Neuron Service Pin

signal

7 (Neuron IO) Neuron IO Reserved

8 (Neuron IO) Neuron IO Reserved

9 (Neuron IO) Neuron IO 4-bit subsystem

selection input (bit 2)

10 (Neuron IO) Neuron IO 4-bit subsystem

selection input (bit 3)

11 Do not connect

12 (Neuron IO) Neuron IO 4-bit subsystem

selection input (bit 1)

13 Do not connect

14 (Neuron IO) Neuron IO 4-bit subsystem

selection input (bit 0)

DM-21 Device Manger Hardware Interface

The front panel of the DM-21 module is shown in figure 4.2. A single Status LED

is provided for the device.