User's Manual

20 Meter Operation
Value Type Item Description
Self-read/One-time-read/
Historical demand reset
Forward – reverse active kWh L1+L2+L3
Self-read/One-time-read/
Historical demand reset
Import reactive kvarh L1+L2+L3
Self-read/One-time-read/
Historical demand reset
Export reactive kvarh L1+L2+L3
Self-read/One-time-read/
Historical demand reset
Power outage duration seconds (accumulation of all outages since last
reset)
Self-read/One-time-read/
Historical demand reset
Power outage count (number of outages since count was last reset to 0)
Self-read/One-time-read/
Historical demand reset
Error Counter – A count of the number of alarms that have occurred for RAM
Failure, Non-Volatile Memory Failure, Clock Error, Measurement Error,
Cover Removed, and Save-All Aborted.
Self-read/Historical
demand reset date and
time
Date and time that a self-read occurred
Note: Self-read and One-time-read values can be configured to display from any of the 24 Self-read or
One-time-read data sets stored in the meter, and for 12 of the historical demand reset data stored in the
meter.
Date Local DST (Daylight Saving Time) date in meter
Time Local DST (Daylight Saving Time) time in meter
Pre-pay, total Prepay credit remaining, in Wh
Pre-pay, emergency Prepay emergency credit remaining, in Wh
TOU calendar ID Identifier of the Time-of-Use calendar that is presently operating
Firmware version Firmware version currently running in the meter. You can configure the
meter to display its firmware version for 1-15 seconds on power-up, if
desired.
When the firmware version is shown on the meter display, the alphabet
character portion is shown as a numeric value. The letter “a” is shown as
01, “b” as 02, “c” as 03, and so on through the alphabet. For example,
firmware version 1.00a is shown on the meter display as 01 00 01.
Disconnect Open The meter can be configured to display the reason the load disconnect
contactor has been opened as a user-specified text string. The following
characters are not supported: K, M, Q, V, W, X.
Note that the digit “2” is used to represent the letter “Z,” the digit “1” is used to
represent the letter “I” and the digit “5” is used to represent the letter “S.”
Demand Resets The number of demand resets that have occurred.
Load Side Voltage
Detected
The meter can be configured to automatically reject remote closing of the
load disconnect contactor when load side voltage is present, and to display
the reason for this as a user-specified text string. The same character
restrictions as described for the Disconnect Open display item above apply.
For more information on this feature, see “Remote Disconnect” on page 1.
Push Button Operation
The push button on the front of the meter (next to the display and labeled LCD),
performs various functions. The button functions are: