User's Manual

104
Interoperable Interface for the Street Light Bridge
Variable
Description
Ok to Modify?
nciPriRpt
Defines the repeat count for the
primary path.
Yes
See Defining the Networking
Channels for information about
defining channels.
nciSecChs
Defines channels for RF data
transmission on the secondary
(alternate) LonTalk (ISO/IEC
14908-3) path.
Valid values are 11 to 26. Values
outside this range are ignored.
Yes
See Defining the Networking
Channels for information about
defining channels.
Use 0 (zero) to indicate an unused
channel.
nciSecRpt
Contains the repeat count used for
the secondary path.
Yes
See Defining the Networking
Channels for information about
defining channels.
nciRepeatMode
Defines the Street Light Bridge
repeating type:
0 – normal repeating operation
(PL and RF)
1 – PL-PL repeating (no RF
transmission)
2 – RF-RF repeating (no PL
transmission)
Yes
See Defining Repeating for
information about setting the
repeat mode.
nciMediaAccess
Defines the power line media
access protocol:
0 – Default (media access protocol
is enabled during manufacturing,
based on the module model type)
1 – Normal (overrides firmware
setting and defines a PL-20N
channel)
2 – CENELEC (overrides firmware
setting and defines a PL-20C
channel)
Yes
See Defining the Media Access
Protocol for information about
setting the media access protocol.
Changes to this value take effect
only after a device resets.